Stern Pinball Repair Service Lamp Driver

Repairs on these boards are fairly easy except for decoder problems. Typically, I bench test the driver circuits and any that seem out of wack get replaced. If entire banks of lamps are malfunctioning, then that's usually a decoder problem. I've also noticed some boards with corrosion damage from a leaking MPU battery. This board sits below the MPU on most machines and if the battery leakage was severe, there will be damage on the lamp driver board too.

All repair jobs include a good cleaning and repairing cracked header pin solder joints.

Here's a table of rates for each type of repair, and all prices include parts and labor. If I can't fix it, you don't pay!

I also ask that you pay return postage, which will be the going rate for U.S. Priority Flat Rate Priority, or International Priority, plus optional insurance.

Stern LDA-100 Lamp Driver Boards Repair to working 100%	$25.00 flat rate
Connector Kit for either board New housings, keys, and plenty of crimp-on pins	$17.00 $15.00 w/ repair
Anything else Resistors, corrosion damage, trace damage, etc.	$5.00 & up plus parts

All prices do not include return shipping

So feel free to send me your board(s) and I'll take a look and let you know what I think, then you can decide what to do from there. Probably a good idea if you e-mail me first, just so I know what to expect (remove the NO_S*P*A*M_).

Here's a picture of an LDA-100 Rev-C board that I recently repaired:

Of course, there's always Ts & Cs (revised), and don't forget prices DO NOT include shipping.

If you decide to "do it yourself", visit Big Daddy or GPE for all the parts you'll need.
I'll still fix it when you're done. :-)

Thanks!